Increase the speed of Linux Software RAID reconstruction
If you are in a situation where you sit in front of the console (or on a remote ssh connection) waiting for a Linux software RAID to finish rebuilding (either you added a new drive, or you replaced a failed one, etc.) then you might be frustrated by how slow this process is running. You are running cat on /proc/mdstat repeatedly (you should really use watch in this case 
), and this seems to never finish… Obviously that there is a logical reason for this ‘slowness‘ and on a production system you should leave it running with the defaults. But in case you want to speed up this process here is how you can do it. This will place a much higher load on the system so you should use it with care.
To see your Linux kernel speed limits imposed on the RAID reconstruction use:
- CODE: SELECT ALL
cat /proc/sys/dev/raid/speed_limit_max
200000
cat /proc/sys/dev/raid/speed_limit_min
1000
In the system logs you can see something similar to:
- CODE: SELECT ALL
md: minimum _guaranteed_ reconstruction speed: 1000 KB/sec/disc.
md: using maximum available idle IO bandwidth (but not more than 200000 KB/sec) for reconstruction.
This means that the minimum guaranteed speed of the rebuild of the array is approx 1MB/s. The actual speed will be higher and will depend on the system load and what other processes are running at that time.
In case you want to increase this minimum speed you need to enter a higher value in speed_limit_min. For example to set this to approx 50 megabytes per second as minimum use:
- CODE: SELECT ALL
echo 50000 >/proc/sys/dev/raid/speed_limit_min
The results are instant… you can return to the watch window to see it running, and hope that this will finish a little faster (this will really depend on the system you are running, the HDDs, controllers, etc.):
- CODE: SELECT ALL
watch cat /proc/mdstat
